Author Guidelines

General requirements

All manuscripts for the Eco Chemical Engineering Journal (EcoChe) must be prepared with the official 2026 MS Word template and submitted through the journal homepage: talenta.usu.ac.id/EcoChe.

  • File format: MS Word only, formatted for direct printing with the camera-ready (CRC) template provided.
  • Language and units: use International System (SI) units; define every non-standard abbreviation or symbol at first use, or supply a glossary.
  • Embedded content: place figures and tables inside the text. Do not send them as separate files.
  • Fonts: use regular fonts only (Times New Roman throughout).
  • Copying text in: if you are moving text from another draft, use Paste Special (unformatted text) to keep the template styles intact.
  • Licence: published articles are released under a Creative Commons Attribution-ShareAlike 4.0 International License.

Page setup and formatting

Use A4 paper, a single-column layout and 2 cm margins on every side. Do not change the margins, or the footer may fall outside the print area.

Element

Font and size

Style

Alignment

Paper title

Times New Roman 16 pt

Bold; capitalize the first letter of each word

Justified

Author names

Times New Roman 14 pt

Regular; affiliation numbers in superscript, corresponding author marked *

Left

Affiliations

Times New Roman 11 pt

Italic; superscript number, then affiliation, city, postal code, country

Left

Abstract

Times New Roman 10 pt

Regular; maximum 250 words

Justified

Section headings (1., 2., …)

Times New Roman 11 pt

Bold, numbered, first letter of first word capitalized

Left

Sub-section headings (1.1, 1.2, …)

Times New Roman 11 pt

Italic, first letter of each word capitalized

Left

Sub-sub-section headings (1.1.1, …)

Times New Roman 11 pt

Italic, first letter of first word only capitalized

Left

Body text

Times New Roman 11 pt

Regular

Justified

References

Times New Roman 11 pt

Numbered list with hanging indent

Justified

Paragraph rules

  • Paragraphs directly under a section heading: justified, no first-line indent.
  • Paragraphs under sub-section and sub-sub-section headings: justified, first line indented 0.42 cm.
  • Leave at least two lines of text after any heading before a page break.
  • Avoid hyphenation at the end of a line.
  • Do not leave blank text areas, except on the last page.

Manuscript structure

Every article follows the IMRAD pattern: Introduction, Method, Results and Discussion, then Conclusion.

Front matter

  • Title: concise and informative, first letter of each word capitalized.
  • Authors: full names, each followed by a superscript affiliation number. Mark the corresponding author with an asterisk (*).
  • Affiliations: one line each: affiliation detail, city, postal code, country.
  • Corresponding author e-mail: an institutional e-mail address is preferred.
  • Article info box: leave the received, revised, accepted, online, E-ISSN and P-ISSN fields as they are; the editorial office fills them in.
  • Abstract: at most 250 words, summarizing the introduction, method, and results and discussion of the whole article.
  • Keywords: 5–10 important words or phrases, listed alphabetically, first letter of the first word capitalized.

Body sections

  1. Introduction: open with a sentence that draws the reader in. Explain the research background and related previous studies, link the problem to your approach, and end with the aim of the research and its main findings. Put nomenclature here.
  2. Method: describe how the research was done, in enough detail to support the findings.
  3. Results and discussion: describe the findings, then analyze them against the research problem stated in the introduction. State whether the hypothesis is supported.
  4. Conclusion: summarize the key findings and discussion.

Back matter (unnumbered headings)

  • Acknowledgements: bold, left-justified, no number.
  • Conflict of interest: a statement is required.
  • References: bold, left-justified, no number; see the References section below.

Tables, figures, equations and units

Tables

  • Number tables with Arabic numerals (Table 1, Table 2, …) and give each one a caption above it.
  • Use horizontal lines only: one above the table, one under the column headings, one below the table. No vertical lines.
  • Embed tables in the text near their first mention.

Figures

  • "Figure" covers photographs, schemes, graphs and diagrams. Number them with Arabic numerals (Figure 1, Figure 2, …).
  • Place the caption below the figure. Define lettering and symbols in the caption or in a legend within the figure.
  • Use a resolution of 300 DPI in PNG, JPEG or GIF. Low-quality scans are not accepted.
  • Place figures at the top or bottom of a page, as close as possible to their first mention. Two small images may sit side by side, labelled (a) and (b).
  • Embed figures in the text; do not supply them separately or put text alongside them.

Equations

  • Type equations with an equation editor (e.g. MathType).
  • Number them consecutively with Arabic numerals in parentheses, right-aligned, e.g. A = πr² (1).
  • Separate each equation from the surrounding text by one blank line.
  • Write vectors and matrices in bold and scalar variables in italics.

Units and abbreviations

Use international standard symbols, with a space between the number and the unit.

Unit

Correct

Incorrect

Example

hectare

ha

Ha, HA, H

1 ha, 254 ha

gram

g

Gr, gr, gm

15 g, 75 g

kilogram

kg

Kg, KG, kgs

10 kg, 40 kg

meter

m

M, mtr, Mtr

5 m, 200 m

References

EcoChe uses the IEEE citation style. A reference manager (e.g. Mendeley or Zotero) is strongly recommended.

In-text citations: number sources in square brackets in order of first appearance: [1]; [1], [2]; [1], [2], [4]; or [1]–[3]. Every cited source must appear in the reference list, and every listed source must be cited.

Reference list: place it at the end of the paper, starting on a new page only if necessary.

Source type

Format

Journal article

[#] A. A. Author, "Title of article," Title of Journal, vol. #, no. #, pp. #–#, Month Year.

Book / e-book

[#] A. Author, Title of Book, ed. Place: Publisher, Year. [Online]. Available: Source.

Book chapter

[#] A. Author, "Chapter title," in Book Title, A. Editor, Ed. Place: Publisher, Year, pp. #–#.

Conference paper

[#] A. Author and B. Author, "Title of paper," in Proc. Title of Conf., Month Date, Year, Location, A. Editor, Eds. Place: Publisher, Year, pp. #–#.

Internet document

[#] A. Author, "Document title," Webpage name, Date. [Online]. Available: URL. [Accessed: Date].

Thesis / dissertation

[#] A. Author, "Title," M.S. thesis / Ph.D. dissertation, Univ., City, Country, Year.

Patent

[#] A. Author, B. Author, U.S. Patent No. #######, Day Month Year.

Report

[#] A. Author, Title of Report, Report no., Organization, City, Year.

Example (journal article):

[1] I. Thompson, "Women and feminism in technical communication," Journal of Business and Technical Communication, vol. 13, no. 2, pp. 154–178, 1999.

The template's reference section has worked examples for 18 source types, including blogs, government publications, encyclopaedias and unpublished reports. Unpublished reports and private communications should be cited only when necessary.

How to cite an EcoChe article:

  1. Haryani, D. Agustini, R. Mahmudah, "Synthesis and Characterization of a Deep Eutectic Solvent Catalyst Using Oxalic Acid Extracted from Averrhoa bilimbi L. for Biodiesel Production," Eco Chemical Engineering Journal, vol. 1, no. 1, 2026, doi: 10.32734/jsi.v7i01.10238.

Submission checklist

Check every item before you submit.

  • ☐ Manuscript prepared in the EcoChe 2026 MS Word template, with margins unchanged
  • ☐ Title in Times New Roman 16 pt bold, first letter of each word capitalized
  • ☐ All authors, affiliations and the corresponding author's (institutional) e-mail included
  • ☐ Abstract of 250 words or fewer, in Times New Roman 10 pt
  • ☐ 5–10 keywords, listed alphabetically
  • ☐ Sections in order: Introduction, Method, Results and discussion, Conclusion
  • ☐ Acknowledgements and Conflict of interest statements included
  • ☐ Tables numbered, captioned above, horizontal lines only
  • ☐ Figures at 300 DPI, numbered, captioned below, embedded in the text
  • ☐ Equations numbered (1), (2), … on the right
  • ☐ SI units and standard abbreviations, with a space between number and unit
  • ☐ All references in IEEE style, numbered in citation order, and every citation matched to a list entry
  • ☐ File saved as .docx

Open question for the editorial team: the template's text says table and figure captions are left-justified and figure captions are 8 pt, but the template's own examples are centered and set in 11 pt. Confirm which rule authors should follow.