Preparation and Characterization of Hierarchical Zeolite from Natural Zeolite Using Tandem Acid–Base Treatments
DOI:
https://doi.org/10.32734/jotp.v8i1.24887Keywords:
Adsorption, Dealumination, Hierarchical, Natural Zeolite, Tandem Acid-Base TreatmentsAbstract
Hierarchical zeolite was successfully synthesized from Lampung natural zeolite via sequential tandem acid–base treatments. The combined dealumination–desilication approach generated additional mesoporosity while preserving the zeolite's crystalline framework, as confirmed by X-ray diffraction (XRD). Nitrogen adsorption–desorption isotherms revealed a transformation from Type I to Type IV behavior, indicating successful mesoporous formation. The BET surface area increased from 4.795 to 16.855 m²/g, accompanied by a significant increase in mesopore volume. Elemental analysis showed that the Si/Al ratio decreased from 8.42 to 2.44 due to the dominant extraction of silicon during alkaline treatment. The modified zeolite (Zeolite-PTAB) exhibited enhanced Cu²⁺ adsorption capacity (19.3 mg/g) compared to raw zeolite (16.1 mg/g), with removal efficiency improving from 53.7% to 64.3%. These findings demonstrate that tandem acid–base treatment provides a simple and effective strategy for upgrading Indonesian natural zeolite into a hierarchical adsorbent for heavy-metal removal applications.
Downloads
References
[1] Istadi, W. Alqurni, and T. Riyanto, ‘Enhancing hierarchical factor (HF) and catalytic performance of Bayah’s natural zeolite catalyst for hydrocracking of palm oil to biofuels’, Int. J. Renew. Energy Dev., vol. 15, no. 2, pp. 216–229, 2026, doi: 10.61435/ijred.2026.61669.
[2] S. Gao, J. Li, X. Wang, Y. Chen, and H. Zhang, ‘Synthesis of zeolites from low-cost feeds and its sustainable environmental applications’, J. Environ. Chem. Eng., vol. 11, no. 1, p. 108995, 2023, doi: 10.1016/j.jece.2022.108995.
[3] E. Cataldo, A. Salviulo, M. P. Colombani, and G. Giordano, ‘Application of zeolites in agriculture and other potential uses: A review’, Agronomy, vol. 11, no. 8, 2021, doi: 10.3390/agronomy11081547.
[4] Y. Li, L. Li, and J. Yu, ‘Applications of zeolites in sustainable chemistry’, Chem, vol. 3, no. 6, pp. 928–949, 2017, doi: 10.1016/j.chempr.2017.10.009.
[5] Y. K. Krisnandi, R. R. Mukti, D. E. S. Purnama, and H. Nur, ‘Synthesis and characterization of crystalline NaY-zeolite from Belitung kaolin as catalyst for n-hexadecane cracking’, Crystals, vol. 9, no. 8, 2019, doi: 10.3390/cryst9080404.
[6] S. Tanirbergenova, A. T. Zhumakanova, A. M. Zharmagambetova, and N. Z. Tashmukhambetova, ‘Effect of acid treatment on the structure of natural zeolite from the Shankhanai deposit’, Processes, vol. 13, no. 9, 2025, doi: 10.3390/pr13092896.
[7] Y. N. Abdulai, M. A. A. Aziz, S. Al-Fatesh, A. Fakeeha, and A. E. Abasaeed, ‘Tailoring acid–base properties in Ni/ZSM-5 catalysts via sequential ion exchange and surface modification for stable dry reforming of methane’, Mol. Catal., vol. 594, p. 115819, 2026, doi: 10.1016/j.mcat.2026.115819.
[8] G. Ancora, F. Morari, J. C. Julio, L. Marchese, C. Bisio, and E. Gianotti, ‘Insights into the role of hierarchical porosity in zeolite architectures for selective uptake of metal ions in solution’, RSC Adv., vol. 15, no. 25, pp. 20092–20110, 2025, doi: 10.1039/d5ra03012a.
[9] Y. Han, K. Larmier, M. Rivallan, and G. D. Pirngruber, ‘Generation of mesoporosity in H–Y zeolites by basic or acid/basic treatments: Towards a guideline of optimal Si/Al ratio and basic reagent’, Microporous Mesoporous Mater., vol. 365, p. 112906, 2024, doi: 10.1016/j.micromeso.2023.112906.
[10] D. S. Oliveira, R. B. Lima, S. B. C. Pergher, and V. P. S. Caldeira, ‘Hierarchical zeolite synthesis by alkaline treatment: Advantages and applications’, Catalysts, vol. 13, no. 2, 2023, doi: 10.3390/catal13020316.
[11] W. J. Roth, B. Gil, K. A. Tarach, and K. Góra-Marek, ‘Top-down engineering of zeolite porosity’, Chem. Soc. Rev., vol. 54, no. 16, pp. 7484–7560, 2025, doi: 10.1039/d5cs00319a.
[12] M. C. Silaghi, C. Chizallet, J. Sauer, and P. Raybaud, ‘Dealumination mechanisms of zeolites and extra-framework aluminum confinement’, J. Catal., vol. 339, pp. 242–255, 2016, doi: 10.1016/j.jcat.2016.04.021.
[13] D. Verboekend and J. Pérez-Ramírez, ‘Design of hierarchical zeolite catalysts by desilication’, Catal. Sci. Technol., vol. 1, no. 6, pp. 879–890, 2011, doi: 10.1039/c1cy00150g.
[14] Y. Han, K. Larmier, M. Rivallan, and G. D. Pirngruber, ‘Generation of mesoporosity in H–Y zeolites by basic or acid/basic treatments: Towards a guideline of optimal Si/Al ratio and basic reagent’, Microporous Mesoporous Mater., vol. 365, p. 112906, 2024, doi: 10.1016/j.micromeso.2023.112906.
[15] N. Elboughdiri, ‘The use of natural zeolite to remove heavy metals Cu (II), Pb (II) and Cd (II) from industrial wastewater’, Cogent Eng., vol. 7, no. 1, 2020, doi: 10.1080/23311916.2020.1782623.
[16] S. R. Zekavat, F. Raouf, and S. S. A. Talesh, ‘Simultaneous adsorption of Cu2+ and Cr (VI) using HDTMA-modified zeolite: isotherm, kinetic, mechanism, and thermodynamic studies’, Water Sci. Technol., vol. 82, no. 9, pp. 1808–1824, 2020, doi: 10.2166/wst.2020.448.
[17] E. Restiawaty, V. A. Gozali, T. A. S. E. Wibisono, and Y. W. Budhi, ‘Utilizing modified clinoptilolite for the adsorption of heavy metal ions in acid mine drainage’, Case Stud. Chem. Environ. Eng., vol. 9, p. 100706, 2024, doi: 10.1016/j.cscee.2024.100706.
[18] J. N. Enemmoh, D. Harbottle, M. Yusuf, and T. N. Hunter, ‘Combined clinoptilolite and Fe(O)OH for efficient removal of Cu(II) and Pb(II) with enhanced solid–liquid separation’, Discov. Chem. Eng., vol. 5, no. 1, 2025, doi: 10.1007/s43938-025-00075-y.
[19] M. Ugrina, I. Nuić, and J. Milojković, ‘Study on the performance of copper(II) sorption using natural and Fe(III)-modified natural zeolite–sorption parameters optimization and mechanism elucidation’, Processes, vol. 13, no. 9, 2025, doi: 10.3390/pr13092672.
[20] C. M. van Genuchten, K. Wang, C. Kjøller, and K. Dideriksen, ‘Molecular-scale investigation of Cu(II) interactions with synthetic and natural zeolites during removal and recovery’, Environ. Sci. Water Res. Technol., vol. 12, no. 1, pp. 314–327, 2026, doi: 10.1039/d5ew00972c.
[21] F. Fu and Q. Wang, ‘Removal of heavy metal ions from wastewaters: A review’, J. Environ. Manage., vol. 92, no. 3, pp. 407–418, 2011, doi: 10.1016/j.jenvman.2010.11.011.
[22] S. Rasamimanana, S. Mignard, and I. Batonneau-Gener, ‘Hierarchical zeolites as adsorbents for mesosulfuron-methyl removal in aqueous phase’, Microporous Mesoporous Mater., vol. 226, pp. 153–161, 2016, doi: 10.1016/j.micromeso.2015.12.014.
[23] M. Thommes, K. Kaneko, A. V. Neimark, J. P. Olivier, F. Rodriguez-Reinoso, J. Rouquerol, and K. S. W. Sing, ‘Physisorption of gases, with special reference to the evaluation of surface area and pore size distribution (IUPAC technical report)’, Pure Appl. Chem., vol. 87, no. 9–10, pp. 1051–1069, 2015, doi: 10.1515/pac-2014-1117.
Downloads
Published
Issue
Section
License
Copyright (c) 2026 Journal of Technomaterial Physics
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
