Design and Construction of the Triple-Layer Counter Flow Concentric Tube
Keywords:Heat Exchanger, Cooper Tube, Annulus, Water Heater
A heat exchanger is a device that produces the transfer of heat from one fluid to another. The study aims to design and build a concentric three-prototype with counterflow to lower the temperature of the hot fluid. The hot fluid flows in the annular part of the second copper tube, and then the cold fluid flows into the third copper tube each through the first copper tube and the annulus. The hot fluid is water at 60ºC, a 1000-watt water heater is used to heat the fluid, and the cold fluid is air at 25ºC. The total length of the four concentric prototypes is the first 2.57-meter diameter copper tube. The diameter of the second copper pipe is 2.22 m1 inch. The copper pipe is 1.74 m long and 13/4 inches in diameter. The fluid that can be measured by a fluid thermometer in and out of the heat exchanger is the thermocouple, which is then processed by the computer through the installation of data acquisition modules and tracerdag software.
C. A. Zuritz, “On The Design of Triple Concentric Prototype,” Journal of Food Process Engineering, vol. 12, pp. 113-130, 1990.
Y. A. Cengel, Heat Transfer: A Practical Approach, 2nd, New York: McGraw-Hill, 2003.
J. P. Holman, Heat Transfer Edisi ke-10, Jakarta: Erlangga, 1997.
F. P. d. Incropera, Fundamentals of Heat and Mass Transfer 6th Edition, New York: John Wiley & Sons, 2007.
S. H. L. A. P. Kakac, HEAT EXCHANGERS Selection, Rating, and Thermal Design, Third Edition, CRC Press, 2012.
K. Thulukkanam, Heat Exchanger Design Handbook, Second Edition, Newyork: Marcel Dekker.In, 2000.
M. A. B. Yunus A Cengel, Thermodynamics An Engineering Approach 5th Edition, Newyork: McGraw-Hill Education, 2006.
A. Wijaya, “Rancang Bangun Alat Penukar Kalor (KONDENSOR) Pipa Ganda Aliran Berlawanan Untuk Menghasilkan Air Panas Sebagai Modifikasi Kondensor AC Split,” Universitas Sumatera Utara, Medan.
How to Cite
Copyright (c) 2022 Jurnal Sistem Teknik Industri
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
The Authors submitting a manuscript do so on the understanding that if accepted for publication, copyright of the article shall be assigned to Jurnal Sistem Teknik Industri (JSTI) and Faculty of Engineering as well as TALENTA Publisher Universitas Sumatera Utara as the publisher of the journal.
Copyright encompasses rights to reproduce and deliver the article in all form and media. The reproduction of any part of this journal, its storage in databases and its transmission by any form or media, will be allowed.